PROSiXTEMP - Resideo Honeywell Home Wireless Temperature Sensor (for ProSeries Control Panels)
ProSeries PROSiXTEMP Product Description:
The Resideo Honeywell Home PROSiXTEMP is a wireless temperature sensor that is intended for use with control panels that support PROSiX-Series devices. The PROSiXTEMP sensor is compatible with the ProSeries PROA7, ProSeries PROA7C, ProSeries Canada PROA7CN, ProSeries PROA7PLUS, ProSeries PROA7PLUSC or ProSeries Canada PROA7PLUSCN all-in-one wireless touchscreen control panels. The PROSiXTEMP sensor sends an alarm or trouble signal to the controller depending on the zone type selected (ex. trouble = Monitor Zone; alarm = 24hr Aux) when the hot/cold temperature limit is exceeded. The PROSiXTEMP sensor also has a front cover tamper switch to eliminate tampering.
To enroll set the PROSiX-Series panel in programming mode and when prompted pull the battery tab to activate the PROSiXTEMP (Use the tamper switch if the battery tab is removed). The LED flashes (up to 20 seconds) during enrollment. When done, the LED is ON for 3 seconds to confirm enrollment. If the device is not successfully enrolled during the enrollment period, the LED turns off and the device powers down. Activate the tamper switch to restart the enrollment process. After enrolling and before mounting, verify adequate signal strength by conducting a sensor test with the device in its intended mounting location. Adjust the device location and orientation as necessary.
If the device is enrolled in a panel different than the intended panel (within the 24-hour enrollment deletion and default), and you are unable to delete it from the unintended panel, reset the device to factory default setting. Once the PROSiXTEMP is enrolled in a system, after 24-hours enrollment timeframe, the sensor cannot be used with another controller until it is removed from the current controller.
Product Features:
- 128-bit AES Encryption (PROSiX-Series)
- Front Cover Tamper
- LED indicators
- Cold Temperature below 45° (7°C)
- Hot Temperature above 95° (35°C)
- Backed by Honeywell's 2-year limited manufacturer's warranty
ProSeries PROSiXTEMP Product Documents:
• ProSeries PROSiXTEMP Wireless Temperature Sensor - Data Sheet
• ProSeries PROSiXTEMP Wireless Temperature Sensor - Installation and Setup Guide
• ProSeries PROSiXTEMP Wireless Temperature Sensor - Quick Installation Guide
ProSeries PROSIXTEMP Product Specifications:
- Dimensions (H x L x W): 1" x 3.13" x 1.61" (25.5mm x 79.5mm x 41mm)
- Mounting Hardware: Included
- Tamper Protected: Yes (Front Cover)
- RF Frequency: 2.4 GHz
- Power Requirements: 1 x 3V Lithium battery (Qty 1; Panasonic CR123A, Huiderui CR123A, Duracell DL123A or Resideo 466)
- Encryption: 128-bit AES
- Operating Temperature: 32° to 122°F (0° to 50°C)
- Relative Humidity: 95%, non-condensing
- Agency Approvals: FCC/IC, ANSI/UL 873 and ANSI/UL 2017, Certified to CAN/CSA STD C22.2 #205
