ADC-FLEX-100-AT - Alarm.com Flex IO Cellular Long-Range Property Sensor (Using AT&T LTE Network)
Alarm.com ADC-FLEX-100-AT Product Description:
The Alarm.com ADC-FLEX-100-AT enables new levels of flexibility for monitoring valuable property and assets anywhere that AT&T cellular LTE connectivity is available. Whether used with a backyard gate or a remote storage unit, the Alarm.com Flex IO empowers users to keep an eye on what matters most. It can be used with the included magnet to monitor doors, gates, and other entryways. It also comes equipped with input and output options for integrating compatible devices that lack long-range connectivity.
Product Features:
- Detect open/close using magnetic reed switch
- Detect state change for third-party device using Loop Input
- Change state of third-party and device using Relay Output (requires DC power to support always-on cellular connection)
- Compatible with AT&T Cellular LTE Network
Alarm.com ADC-FLEX-100-AT Product Documents:
• Data Sheet for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
• Installation Guide for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
• Loop Input or Relay Output Installation for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
• Pull Apart Installation Guide for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
• Use Cases for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
• Loop Input Wire Length Supported for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
• Advanced Troubleshooting Using MobileTech for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
• LED Patterns and Troubleshooting for Alarm.com Flex IO Cellular AT&T LTE Long-Range Property Sensor (ADC-FLEX-100-AT)
Alarm.com ADC-FLEX-100-AT Product Specifications:
- Main Unit Dimensions: 6.8 x 2.2 x 1.3" (17.3 x 5.6 x 3.3 cm)
- Magnet Dimensions: 3.1 x 0.68 x 0.87" (7.9 x 1.7 x 2.2 cm)
- Power: Works with DC-wired power or battery power (battery backup recommended for wired installations).
- Power Requirements: 6 to 15 VDC supply. Minimum 1 A.
- Battery Power: Four 1.5 V AA lithium batteries (iron disulfide). 2+ years of battery life, depending on battery chemistry and operating temperature.
- Cellular Communication: AT&T LTE Network
Alarm.com ADC-FLEX-100-AT In The Box:
- Optional EOL (end of line) resistor to detect cut wires. EOL resistor can be 300 kΩ or higher. Normally Open configuration is preferred for low power usage.
- Optional mount tamper and battery door tamper alerts
- Multiple mounting options, including screws or zip ties.
