ADC-EPB-BC2.1-HW - Alarm.com Stationary Emergency Call Button with 2GIG Transmitter
Please Note: The Alarm.com ADC-EPB-BC2.1-HW stationary emergency call button, with 2GIG transmitter, has been discontinued without replacement.
Alarm.com ADC-EPB-BC2.1-HW Product Description:
The Alarm.com ADC-EPB-BC2.1-HW is stationary emergency button with a 2GIG trasmitter for secure independant homecare and senior living. The ADC-EPB-BC2.1-HW emergency button grants caregivers real-time insight into each client's current conditions as well as potential emergency problems.
Alarm.com ADC-EPB-BC2.1-HW Product Documents:
• Datasheet for Alarm.com Emergency Call Button with 2GIG Transmitter (ADC-EPB-BC2.1-HW)
Alarm.com ADC-EPB-BC2.1-HW Product Specifications:
- Enclosure: 4.75 in. x 2.25 in. (Diameter x Depth) Black, ABS plastic base with slip-resistant feet and 3 x AAA battery housing for optional audible message on button press Red, ABS plastic, spring-loaded push button
- Electronic Signaling: Battery-powered filter circuit with integrated 345 MHz (crystal-controlled) 2GIG-compatible transmitter with 64 minute supervisory interval
- Sensing Interface: Filtered, normally open (i.e. when not pressed), momentary contact switch
- Battery Life: Replaceable 3x AAA battery: 2+ years
Alarm.com ADC-EPB-BC2.1-HW Product Programming:
- Use the Alarm.com AirFX "Add a Sensor" interface or the panel interface to add the button to the account. Set the "New Sensor Information" as shown in the chart. Please note that "Alarm type 24hr aux Alarm" should be used if the button is used to signal an emergency. "Alarm type no response" can be used if the button is not being used to signal an emergency.
- After the sensor is added to the system, change the sensor type to "Push Button." From the Equipment page of the Dealer Website click Change to the right of the sensor's name. Select the "Change Sensor Type" action, and update the new sensor type to "Push Button."
Sensor ID Select an unused ID
Sensor Type Alarm type 24hr aux Alarm (Emergency) or Alarm type no response (Non-Emergency)
Equipment Type Contact
Equipment Code 491
Serial Number On the bottom of the device
Equipment Age New
Sensor Loop Number 2
Dialer Delay Any
Voice Descriptor Any
Reports Enabled
Supervised Enabled
Chime Any
Alarm.com ADC-EPB-BC2.1-HW Product Installation:
Locate the sensor within 100 feet of the base station. Ensure that the On/Off switch on the base of the button is set to the "On" position. The sensor can be mounted using the included mounting plate and mounting hardware or simply place the sensor on a flat surface in a visible location.
