RE659 - Alula Wireless 360 Degree Motion Detector (for Connect+ Panel)
Please Note: The Alula RE659 wireless 360 degree motion detector is a special order item.
Alula RE659 Product Description:
The Alula RE659 is a wireless Connect+ encrypted, ceiling-mount, 360 Degree motion detector designed for the Alula Connect+ control panel. With a range of up to 40 feet diameter, the RE653 protects indoor areas and goes into alarm when motion is sensed.
To enroll the RE659, begin by entering the serial number into the security panel. Alternatively, the sensor can be enrolled by placing the panel into enrollment mode, and then pulling the battery tab or tampering the device.
To install the RE653, begin by screwing two #8 screws into the ceiling, leaving 1/4 inch of thread exposed. Next, slide the back plate over the screws and rotate the back plate. Screw the third #8 screw through the wall tamper into the ceiling, ensuring that the wall tamper screw is attached to something solid. Tighten all screws until snug. Then, insert the square nut into the square slit of the cover and start threading the #4 screw into the side of the cover. Close the cover and conduct a walk test. After testing, take the unit out of walk test mode and close the cover again. Finally, finish threading the #4 screw until it is snug.
Product Features:
- 360° detection range with 62 distinct detection zones
- Range up to 40 feet in diameter
- Selectable pulse count 2 or 4
- Designed for commercial applications
- 5 year warranty
Alula RE659 Product Specifications:
- Dimensions: 4.72 x 1.57 inches (40 x 120 mm)
- Weight with Battery: 4.2oz (120g)
- Mounting Fasteners: (3) #8 screws, (1) square nut, (1) #4 screw (All provided)
- Operating Temperature: 32 to 120°F (0 to 49°C)
- Maximum Humidity: 85% non-condensing relative humidity
- Weatherproof: IP55
- Frequency: 433.92 MHz
- Replacement Battery: One Panasonic CR123A
- Nominal Battery Life: 3 years (720 trips per day), 7 years (240 trips per day)
- Battery Voltage: 3.0 VDC (Nominal), 2.7 VDC (Low)
- Current Draw: 21 mA (Maximum), 4.7 µA (Standby), 30 mA (Max in walk test)
- Mounting Height: 2.5 to 4 feet (0.8 to 1.2m)
- Detection Range: Up to 40 Feet (12 m)
- Detectable Speed: 1 to 5 feet per second (0.3 to 1.5 metres per second)
- Transmitted Indications: Motion, Cover Tamper, Wall Tamper, Low Battery, Supervision
- Certification: UL639, ULC-S306-03, ETL, FCC, IC
Alula RE659 Product Mounting Tips:
- Avoid direct sunlight
- Avoid facing directly to AC or heating vents
- Avoid vapor or high humidity
- Avoid curtains, screens, etc. from blocking detection
- Do not install outdoors
Alula RE659 Product Pro Tips:
- Save battery life by taking unit out of walk test mode after completing walk test. There is no 2 minute delay when in walk test mode. Leaving in walk test mode will severely decrease battery life.
- Light changes will cause the sensor to trip. Ensure that the detector is not placed near windows.
- Sudden temperature changes will cause the sensor to trip. Ensure the motion detector is not placed near heating and cooling vents.
- High humidity environments can cause condensation of the detection lens. Ensure the motion detector is not installed in these kinds of environments.
- Protective film should be removed from the lens after installation.
