The Honeywell 5800C2W Convert to Wireless Module (referred to as the 5800C2W, module, or 5800C2WCN in Canada) provides the option to retrofit existing security systems by; converting their wired sensors to Honeywell's 5800-Series wireless technology, and replacing the existing control panel with a LYNX Touch or LYNX Plus series control. The 5800C2W also works with residential VISTA control panels equipped with a wireless RF receiver and keypad.
Please note, the 5800C2W is not for use with fire or heat sensors and it is recommended that any existing smoke, heat or CO detectors be replaced with new Honeywell 5800-Series detectors. All zones that are used MUST have an EOL resistor. If the existing existing installation zones have EOL resistors (from 1k to 10k ohms) they may remain. EOL resistor values must be from 1k to 10k ohms. For a NC loop without an EOL resistor, you must add one in series with the loop. For a NO loop without an EOL resistor, you must add one in parallel (across) the loop. Preferably it should be located at the end of the loop furthest away from the control panel.
The 5800C2W eliminates the labor and expense of adding new transmitters to the system's protection points by using existing wired infrastructure. Ideal for retrofits and new construction installations that have been fitted with hardwired systems.
Nine hardwired zones with end-of-line resistor protection use with existing contacts, PIRs, glassbreaks and other 12V sensors
One-button calibration/activation of zone inputs
5800C2W wireless zones enroll in the control panel like any other 5800 Series device
5800-Series serial numbers automatically assigned to activated zones
Power supply included to power PIRs, 12V 4AH battery provides four hours of standby, Low battery supervision and notification
Case tamper switch
Onboard battery charger for standard backup battery
Complete supervision of transmitters, zone tampers, low battery
Module can be mounted next to the control panel being replaced, or relocated if necessary to maximize wireless range
Dimensions: 7.0" L x 4.50" W x 1.5" D (178 mm L x 114 mm W x 38 mm H)
Mounting Hardware: Double stick tape and screws included
Operating Temperature: -10°C to +60°C (+14°F to +140°F)
Humidity: 95% RH Max
Transmission Range: Up to 91 meters (300 feet)
Operating Voltage: Supplied by plug-in power supply (15.5VDC @ 1A)
Battery Backup (not included): Use 12V, 4AH battery such as Honeywell 467, Yuasa NP4-12, Casil CA1240 or equivalent. Provides four hours of backup. Battery is to be located in the existing control panel. DO NOT use batteries of larger capacity.
Tamper Detection: Activated when the cover is removed
5800C2W Supervision: Low battery, Backup battery power, Each enrolled zone transmits a supervisory message every 72 minutes
LED Status Indicators: Input power, Backup power, Wireless transmission
Input Zones (Nine Hardwired): All zones that are used must have an EOL resistor
Auxiliary Output (12VAUX): Provides 9.5 to 14VDC @ 100mA to supply PIR motion or glassbreak sensors
Agency Listings: ETL Listed to UL 1023, cETL Listed to ULC-C1023