The Radio CT110 is a smart thermostat designed for Z-Wave home automation hubs. The CT110 thermostat has an aesthetically pleasing white-colored thin design, and 2H/2C with heat pump. This Radio thermostat runs on 4 AA batteries which are not included. If you would like us to ship the CT110 with batteries, please select the add batteries drop-down above to read, "upgrade to CT110RTP-AAKIT Radio".
You will need a small Phillips screwdriver and a drill with 3/16-in. (4.8mm) bit for wall mounts. Please remember to switch OFF electricity to the HEATING and COOLING systems. You will want to mount the CT110 in the same place of the old thermostat. A new location will require moving your wiring.
Locate the thermostat on an inside wall, about 5 ft. (1.5m) above the floor, and in a room that is used often.
Do not install it where there are unusual heating conditions, such as: in direct sunlight; near a lamp, radio, television, radiator register, fireplace; near hot water pipes in a wall; or near a stove on the other side of a wall.
Do not locate in unusual cooling conditions, such as: on a wall separating an unheated room; or in a draft from a stairwell, door, or window.
Do not locate in a damp area. This can lead to corrosion that will shorten thermostat life.
Do not locate where air circulation is poor, such as: in a corner, an alcove; behind an open door.
Do not install the CT110 until all construction and painting has been completed.